Concrete Bonding Chemical
Our squad of dexterous professionals assists us offer premium quality Concrete Bonding Chemical. Offered chemical is processed from high quality basic chemical compounds and advanced technology at our hi-tech processing unit. Moreover, the offered chemical is used for bonding old concrete to new concrete. To assure its high quality and purity, this chemical is examined on various quality parameters by our experts. We offer this Concrete Bonding Chemical in various quantity packing options at industry leading rates to our clients.
Longer shelf life
Typical Applications: For bonding old concrete to new concrete.
PACKING: Perma Master Bond available in 1 KG as well as bulk packing on special request.
COVERAGE: 1 kg covers an area of 30 sqft.
It is a two components, and lasting epoxy adhesive. The chemical substance is ideal for internal bonding, rendering, and concrete etc. It offers ultimate bond strength, providing even & stress-free bonds.
- Useful in bonding old concrete to new one.
- Concrete as well as floor repair mortar.
Directions For Use :Preparation:
All surfaces going to be applied with this must be well cleaned and prepared. The dust, curing compounds, oil, grease, floor hardeners, loose particles, fat, paint and bitumen must be removed from the surfaces so as to attain a good bond strength. Glossy surfaces must be rub off.If there is an occurrence of oil or grease, scrub the surface with hot purifying water and wash completely. Where the concrete opencast is badly decomposing, the degenerated orbits should be separated via the procedures of scrabbling, chipping or grit blasting, until a good base is acquired. The removal of loose particles as well as laitence is needed via the assistance of sandblasting, mechanical scarification and acid etching. Visible marks of mold growth, algae or lichen should be treated with a anti-fungal wash. New concrete should have processed until the shrinking as well as moisture motility is low. Surfaces heavily infused with mold oil should be sandblasted, degreased or mechanically scored to take away the dirt from the surface. The application of the product needs a clean & dust free surface.
Carefully convey the total contents of the smaller instrumentality of reactor component to the larger base component and blend soundly with the utilization of a stout & palette knife or by using slow running tool with a paint mixing bat until the consistency is attained. This usually takes two to three minutes.Note: Heat is made after mixing Concrete Bonding Chemical and can become too warm to hold.Guide to Application:
The material is ready for its utilization after 3 or 4 minutes of mixing. As the serviceability of pot life is less, work should be proceed rapidly. The product should be applied equally across the total surface with a cleaned, short hairy paint brush. The cans' contents must be taken in use within 45 minutes of mixture. On horizontal surfaces, place the screed instantly after utilizing this product. Performance more than 6 mm thickness can be attained with several layers.Rendering and Screeds:
Once this bonding product is applied, accepted techniques of working may be followed. It is necessary that sand cement renders, granolithic paving and screeds are well-cured. This can be attained by curing with a precise spray of polythene sheeting and clean water. If these precautions are failed, it can cause the screed or render to fad & crack. Temperature
Since low temperatures detain the curing as well as setting of Concrete Bonding Chemical, the products are not recommended to use in cold weather. Although it cures slowly at reduced temperatures, a temperature of 7°C can be well-advised to be the lowest at which activity on vertical rendition may be continues satisfactorily without the problem of stuttering.Advantages:
- High strength, durability & non-shrink
- Resistant to chemical etc.
- Provided in pre-weighed units
- Advanced epoxy insensitive to moisture
Click here for more details